3D Tools
3D Print with us
Checking your session…
Text
1 line
Believe It
Press Enter for a new line. Up to 6 lines.
Font
DynaPuff
Cherry Bomb One
Gveret Levin
Each face is bundled at the one weight it has — DynaPuff 700, Cherry Bomb One 400, Gveret Levin 400.
Text alignment
Left
Centre
Right
Aligns the lines against each other. The block of text stays centred in the frame either way.
Font size
22 mm
The type's em size, not the letter height — the letters come out around three quarters of it. Text too big to fit is refused with the largest size that would.
Text height
5 mm
How far the letters stand off the wall, toward you. Keep it low: tall letters standing on a thread footing lean.
Frame size, across the flats
160 mm
One number, because a regular hexagon has one. Measured flat to opposite flat, which is the frame's height — corner to corner it is 15% wider, so the cap is 216 mm to keep it on an A1 bed.
Frame bar width
12 mm
12 mm is the floor: the hanger's 9 mm keyhole chamber needs 1.5 mm of wall on each side.
Frame depth
12 mm
12 mm is the floor: the hanger pocket is 8 mm deep and wants 4 mm of material in front of it.
Inner corner radius
1.4 mm
Outer corner radius
2 mm
Rounds the six points off. It pulls the corner-to-corner width in as it goes — the flats stay exactly where they are, which is why the size control measures those.
Thread width
0.5 mm
0.42 mm is one extrusion at a 0.4 nozzle. Below it the slicer finds nothing to lay a bead into and drops the thread entirely.
Thread spacing
7 mm
Centre to centre within each diagonal family. 7 mm is what printed cleanly and holds every letter.
Offset, first diagonal
0 mm
Slides every thread of this family together. At 0 one of them passes through the centre of the frame.
Offset, second diagonal
0 mm
Same for the family running the other way. Use these to drop a lightly held letter onto a thread crossing.
Generate frame
A few seconds — no upload step.
Your 3D preview appears here.