37,800 combinations of profile, plan shape, cutout, texture and floor, before any of the dimensions are touched.

SizeHow big, and how thick

Height90 mm

Floor to rim. Tall enough and the flame sits down a chimney, so most of the light leaves through the pattern rather than the top.

Diameter at the floor72 mm

Diameter at the rim72 mm

The cavity has to stay clear of 40 mm the whole way down, because the candle is dropped in from the top.

Wall thickness2.4 mm

Measured square to the wall, not horizontally, so a flared body keeps its thickness instead of thinning out.

Floor thickness3.0 mm

SilhouetteThe profile from the side

Profile

A single belly at half height.

Profile strength18 %

How far the profile departs from a straight taper.

Twist0 °

Total rotation from floor to rim. The cross-section and the pattern both wind round with it.

Cross-sectionThe shape in plan

Plan shape

A plain circle. Nothing to count, nothing to deepen.

LightWhere the glow gets out

Cutout pattern

A lattice of diamonds on point.

Repeats around12

Repeats up the band4

Opening60 %

How much of each repeat is hole rather than material. Push it far enough and the webs between openings get too thin to survive being picked up, which the generator will say so rather than let happen.

Solid band at the base14 mm

Kept plain, which hides the candle's metal cup and gives the print something square to start on.

Solid band at the rim8 mm

Take it to zero and the pattern runs off the top edge, leaving a castellated rim.

SurfaceRelief on the outside

Texture

No relief. The silhouette does all the work.

RimThe lip at the top

Rim flare0.0 mm

FloorSolid, or vented

Floor style

A closed floor. Simplest, and it catches any spilled wax.

DetailSmoothness against file size

Facet size1.4 mm

How far apart the mesh's own points sit. Lower is rounder and a much bigger file; past about 1 mm on a large holder there is nothing left to see at print resolution.

Your 3D preview appears here.